Started this discussion. Last reply by Onno Kok Feb 5, 2013.
Started this discussion. Last reply by Onno Kok Jan 13, 2012.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
Just got a rip-cut and installed my Bosch saw haven't used it yet but saw was a good fit. Got the original ripcut and didn't really like it had trouble cutting straight. New one has several improvements should make it work much better. especially…Continue
Started by William Burt Brown in General Woodworking Mar 17.
Is the screw driver impact drill rated?Continue
Started by Bob Naylor in Beginners' Zone Mar 10.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 4 Comments
© 2021 Created by KregRep.
Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service
Comment Wall (3 comments)
You need to be a member of Kreg Owners' Community to add comments!
Join Kreg Owners' Community
-- As for brake pads, I just replaced the rear pads on my GS. I was returning from a trip and could hear some scraping. Upon inspection, I couldn't see any facings. I had just had a 12K service done before the trip - and upon inquiring - "yes, we check the pads". BS!!! 3000 highway miles and nothing left - they didn't check! At least I didn't ruin the disc.
--First woodworking project will be some storage shelves - then it is on to installing some (more) laminate flooring - no need for the Kreg system there.
--We were to have departed for a mc campout today, but it'll just have to wait until the morning.
John P.
- Good luck, and good woodworking!