I am making an 75" x 40" frame with 2X4s and want each corner square. Now if I was using nails I would place one in each joint then measure the diagnols and square it up before putting more nails…Continue
Started this discussion. Last reply by Steve Bennett Jun 19, 2011.
This is my first project with the jig. I am making a frame with 2x4s joining them at right angles. Since they are both 1 1/2 thick I set the jig guide and the drill length at 1 1/2. Then based on…Continue
Started this discussion. Last reply by Larry Mathews Jun 13, 2011.