Started this discussion. Last reply by Tim Roman Dec 18, 2012.
Started this discussion. Last reply by Ken Darga Nov 11, 2012.
Started May 15, 2011
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I have had the ACS for about a year. Was wondering if there any other blades, like a Diablo, that will fit the saw?Continue
Started by Randall H Gress in Beginners' Zone on Saturday.
I have been using the Automaxx 6" clamp for two plus years, and recently the clamp is impossible to close the handles to secure the work and my jig. I cannot close the handles no matter how much pressure I can exert. I open the clamp to max to reset…Continue
Tags: clamp, inch, 6, Automaxx
Started by Anthony M Calabrese in Other Kreg® Products Feb 12.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 2 Comments
© 2021 Created by KregRep.
Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service
Comment Wall (12 comments)
You need to be a member of Kreg Owners' Community to add comments!
Join Kreg Owners' Community
arevee1@aol.com
Hi Kenny,
I must of just missed you guys last night, but I read about your wifes problem with her knee. If it makes you fell any better let her know I had both mine replaced and I would do it again in a heartbeat. I didn't have any problems at all, and just a little bit of pain, but you have to do the therapy afterwards
Ray
thank you kenny. i'll get back to you with some stuff
Kenny,
Keep in mind that the depth of the hole being drilled also has to compensate for the different screw lengths. Although the depth might be different than you think in some cases, this is simply because the recommended screw for that particular application has changed as well.
KregRep
View All Comments