Not sure if anyone has had this issue. I have the Rip-Cut Ruler and I use it a lot to rip boards for cabinets.Now the ruler's ink has been rubbing off with the sliding of the saw.Has anyone else had…Continue
Started this discussion. Last reply by Glen S Oct 2, 2018.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
1 |
K5 Repair |
2 |
Keepsake Box |
3 |
Turned Wands |
4 |
Boxes |
5 |
Turned Pipes |
6 |
Pizza Cutters |
7 |
Bookmarks |
8 |
Coffin Shelf |
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service
Comment Wall (1 comment)
You need to be a member of Kreg Owners' Community to add comments!
Join Kreg Owners' Community
Hello there Cynthia, good morning to you, well I would contact as I have tried the Customer service team at Kreg, but for what ever reason when I enter either my land line or cell phone number it comes up as invalid and when I try to send the email it will not go due to this. Seems if you live in America its no problem, me I live in the Philippines. Anyway will try to find away as I did once contact the technical team via email but forgot how I got there. The main issue with this rip-cut when I set up the blade to be close to the Edge guide, with the Indexing stop in place it leaves a gap from the blade to the edge guide of about 4mm and the Cursor is just about hanging on in place. With the Indexing stop removed then I can line things up. Will keep you advised on what happens next. Cannot do much today or tomorrow as have to be out the house. Bye for now, enjoy your day there. ken