Thanks Billy for getting back to me about the router bits. I was wondering as in looking at the door edges and panels and blowing up the photos I could see that the material was cut with a quality bit. I have been building cabinets over 20 years and use CMT bits. I build a large amount of doors and was particular interested in how well the edges were cut . I have viewed your work on these cabinets and honestly I am impressed with them. I would put you to work in my shop any day. I build nothing but custom work and when I tell you this I am giving you a very high compliment. Again Thank You for answering my question as I am always on the look out for new tools. Wishing you and yours the very the very best of the Holidays and continued health and happiness through out the coming year.
I've been using my Adaptive Cutting System table for a few years now, and it's been really solid. This past week was the first time I ever needed to use the miter guide though.I was rebuilding some shelving in a tiny closet and I discovered the…Continue
I am building a small trunk for a military friend to put some belongings in. I have made legs out of ash hardwood and will make the sides out of 1/2” or 3/4” Baltic birch plywood. The legs are 1.5” thick by 2” wide. So since I’m drilling pockets in…Continue
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…