Has anyone had any problems drilling into hardwoods? I normally build with softer woods and sheet goods but over the weekend I put together a hardwood face frame and found that I got some wood burn…Continue
Started this discussion. Last reply by Al Barale Sep 3, 2011.
I just wondered how everyone else goes about deciding what dimensions to use for frame widths etc. How do you come up with height vs length vs depth ratio's. I have looked at Fibonacci's golden ratio…Continue
Started May 20, 2011
Okay so I am basically tearing into every piece of furniture that I can find to see how it is constructed and joined in my aim of self improvement. So I have been looking at my coffee table that was…Continue
Started this discussion. Last reply by mo khan May 23, 2011.
Anyone got a clue or built something like the wall cabinet in this picture? I am thinking that it will be made with a veneer covering a frame? Continue
Started this discussion. Last reply by Jay Boutwell Apr 27, 2011.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
1 |
K5 Repair |
2 |
Keepsake Box |
3 |
Turned Wands |
4 |
Boxes |
5 |
Turned Pipes |
6 |
Pizza Cutters |
7 |
Bookmarks |
8 |
Coffin Shelf |
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service
Comment Wall (2 comments)
You need to be a member of Kreg Owners' Community to add comments!
Join Kreg Owners' Community
Hi Jim, thanks for that. that is a sure easier way that what I used on my last project. I put a dado in each of the sides of the drawer and then added a "L" shaped piece from the inside of the top that would run inside the dado. There are a 100 ways to fit a drawer!
http://kregjig.ning.com/photo/img-1571?context=user
http://kregjig.ning.com/photo/img-1609?context=user
Hi Alex, here are a couple of pics of how i did the drawers.
Because these drawers won't be used that frequently I opted just to install guides made from some leftover 3/8 hardboard for the bottom and a couple of pieces of 2x scrap for the sides.
On the back of the drawer I glued a guide to keep the drawer from tipping when it is pulled out.