this one had a bigger base

Comment

Comment by fatboyzz.custom on August 17, 2012 at 7:26pm

 yea the other ten with alil bit smaller base and different tops have been in uses for about 2 years,,  the rails that you put your feet on are 3/4 dowd and glued and screwed and peged,,  the appron around the top and the seat is attached with kreg jig,,  nice and heavy,,  theses are not no hollywood stuntmen type bar stools here cause the stuntmen would brake before they would

Comment by A.E. "Buddy" Holmes on August 17, 2012 at 5:21pm

Thanks for the reply. Looks like a nice design and they have proven to hold up under commercial use!

Comment by fatboyzz.custom on August 17, 2012 at 3:15pm

alil more then a 8 degree angel,,  top and bottom has to be cut cross the byass to work right,, i made a jig to build these bar stool bottom on and screwed it to a peice of plywood so i could use it over and over,, makes it alot eazyer to keep them straight why you are putting them togetheir

Comment by A.E. "Buddy" Holmes on August 16, 2012 at 6:57pm

Nice Job!  Do you recall the angles used on your miter saw?