Comment
Boy, It probably hurt after the fact. I am glad you didn't lose the whole finger. I am glad your tough ole gal. Accidents do happen when you are not expecting it. I am glad that you are back in the saddle again.
The nail will surely grow back later on. I hope your finger gets better. Take Care.
As one of my former managers used to say, "Slow DOWN, We are in a hurry!".
Safety takes a minute but injuries can last a long time.
Here's to a speedy recovery.
Not too bad today, I was holding the wood in place, drilling a 3" screw in as hard as I could (Pressure treated wood), slipped, ouch!@x%*^&^%$
Went right into my nail, broke a tiny bone.
The worst part, when the nail was removed at work ER to release pressure.
But, back in the saddle, rafters going on this am!
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service
You need to be a member of Kreg Owners' Community to add comments!
Join Kreg Owners' Community