Completed

Comment

Comment by Joseph M. on October 24, 2010 at 9:43am

The hardboard is at the same level as the table. you only have that small depression on the right.

Comment by Joseph M. on October 24, 2010 at 9:39am

Comment by Joseph M. on October 24, 2010 at 9:34am

Very nice cabinet. About the Ryobi tools - I also have them and use the table saw. It cuts great however as you mentioned there is a problem with the clearance plate. Initially I added two washers under it because it dropped lower than the table. It helped but you still have that big gap and cannot cut small pieces safely. I managed to create a zero clearance plate out of 1/4" hardboard and it works great. There is still a small depression but its alot safer. I will come back with a photo.

Comment by John A Cason II on September 30, 2010 at 9:45pm

the band saw for ryobi is awsome. the table does really well. when cutting on the side that has the red plastic peiece by the blade can cause a slight angle on the wood. but for anything bigger than 1.5 inches you are good to go. i have not had any issues with ryobi tools and they have preformed pretty well for me so far...that and you cant beat the price. vasil i will send them here shortly. i have them in sketch up

Comment by Doug Fish on September 30, 2010 at 5:52am

Another excellent project! By the way, I notice that you have a lot of Ryobi tools and I was wondering how you feel about their performance, in particular, the bench top band saw? Would you purchase it again? I have mostly Ryobi tools and they have performed well and I need a bandsaw. Thanks.

Comment by Vasil, Mencev on September 29, 2010 at 11:20pm

I realy like it too,also I think you did a realy great job if you don't mind can you send me the plans here is my E-mail vmmacman@yahoo.com and Thank you.

Comment by Al LeCroy on July 25, 2010 at 3:14pm

You can send it to al@cfl.rr.com Thanks

Comment by John A Cason II on July 24, 2010 at 12:14pm

Al, i do have the plans in google sketchup. if you would like i can email them, just send me your email and i will get them out. i do believe i have a cut list for it too still.

Comment by Al LeCroy on July 23, 2010 at 1:37pm

I really like this project, are there plans available?