This was horrible. The clear coat I applied was not compatible with the stain I had applied or something to that affect... and the result was very bad. I ended up having to apply chemical cleaners and scrape the entire thing down again.
Tags:
Projects: My First Project - Cherry iMac Desk
Comment
Robert,
I disagree with your statement---
''...one of my occasional failures.''
I'd refer to it as ''a learning experience.''
Derek,
Interesting unwanted effect, I had the same result with one of my Crown Molding boxes, and later found out that the Indian Ink I used to produce the ebony finish reacted to the Clear Coat, still haven finished the project, mainly due to the unsatisfactory finish the hours I spend preparing veneer burls and the physical construction. I must admit though the box did look superb prior to me allpying the Clear Coat, its in the gallery somwhere, one of my occasional failures.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
1 |
K5 Repair |
2 |
Keepsake Box |
3 |
Turned Wands |
4 |
Boxes |
5 |
Turned Pipes |
6 |
Pizza Cutters |
7 |
Bookmarks |
8 |
Coffin Shelf |
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service
You need to be a member of Kreg Owners' Community to add comments!
Join Kreg Owners' Community