Router Table

Comment

Comment by Steven Akers on May 31, 2011 at 2:54pm

Thanks.

Comment by Steven Oxendine on May 31, 2011 at 8:32am

OK... The magazine I based the design off of is Workshop Solutions. It is still available at Lowes or other places until the end of June.

Comment by Steven Akers on May 25, 2011 at 6:23pm

Thanks for the info.  The magazine info would be greatly appreciated.

Comment by Steven Oxendine on May 25, 2011 at 8:24am

I built this in three evenings after I got home from work. It is 36" X36" overall. The top is a double layer of Melamine with the miter groove and t-slots routered in. I bought the router plate, t-slots and miter groove from Rockler. The base for the top is cabinet grade plywood ripped down to 6 ". This table was in a magazine and I made some modifications like the castors to make it portable. I will let you know what magazine it was that I seen it in.

Comment by Steven Akers on May 24, 2011 at 6:55pm

What are the dimensions?  Thickness?  I've been kicking around the idea of making one.  I have a factory made table that I have modified and it does pretty good now.  The fence would flex, table was too small, etc.  Made a new fence and extensions for the table.  I use the table a good bit so I need to upgrade.  Maybe this winter.  Keep up the good work.

Comment by Steven Oxendine on May 24, 2011 at 7:59am

Thank you!

Comment by Steven Akers on May 23, 2011 at 5:01pm

Very nice router table.  The edge banding is a good idea.  Should help with dings.