Kreg Owners' Community

Modified a plan from the website to make a nightstand but added a shelf and mesh sides and door instead of wood.

  • Currently 0/5 stars.

Views: 1806

Projects: Bedside Table


You need to be a member of Kreg Owners' Community to add comments!

Join Kreg Owners' Community

Comment by Paul S on June 13, 2014 at 12:58pm

Well done, looks great.

Comment by Andy Harris on February 24, 2014 at 9:26am

Michael I based it on this plan from the Ana White site.

I didn't do any formal plans.  I just know I wanted the top to be made up of 5 1x4's joined together and based the rest off that.  The width of the top is 20 by 17.5 deep with a 1.5 inch overhang.  The sides without top were 26 inches high with a 5 inch gap between the bottom of the top 2 inch rail and the shelf.  The rest I made up as I went based off Ana's plan.  Hope that helps. 

Comment by Michael Roop on February 23, 2014 at 2:02pm
Andy is there any chance of getting your plans for this nightstand ?
Comment by David on February 2, 2014 at 6:30pm

Very nicely done

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 


  • Add Videos
  • View All


Concealed Hinge Jig Setting Confusion

The Kreg Concealed Hinge Jig has a setting for the distance from edge of the door to the nearest edge of the 35 mm cup hole. This can be set as 3, 4, 5, or 6 mm.Later in the instruction there is a table that converts the distance from the edge of…Continue

Started by Ken Kortch in Kreg Jig® Operation Oct 11.

Help with old Rip-Cut(tm)

I have an old Rip-Cut which I bought many years ago but did not set.  I seem to have lost the instructions, if I ever had them.I cannot figure out which bolts are match with the nylon-lock screws.This unit is old enough that the current instructions…Continue

Started by Sean in Other Kreg® Products Oct 4.

Product Reviews

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…


Posted by Robert Ringel on September 17, 2020 at 1:48pm — 1 Comment

Kreg Jig Dust Collection Attachment

1st impression when you hold this attachment in your hand:  "not much to it", Kreg sure is makin' $$ here.

Then I installed it.. perfect fit, leaves just enough room to adjust the setting screw on my K4.

Then the real test, hook…


Posted by Grampy Meyer on February 23, 2020 at 11:36am

© 2020   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service