Comment
Yeah you're right their blades do suck! You probably get a lot more bang for the buck ripping them yourself. They charge 20 dollars for a 1/2 inch 2 feet by 4 feet birchwood board.
8 sets in 12 hours is very impressive by the way! Do you use the HLVP sprayer if you're just going to spray the whole thing with a solid color and then add the logo on?
Oh ok that makes perfect sense. Do you cut the 2 ft x 4 ft plywood boards yourself or buy them precut from Home Depot?
So you use just regular plywood over birch plywood? I think that's what was happening to me (using the SPS over the SML type). The wooden pieces at the top and bottom don't look as thick as 5/4 x 4 pine boards. Are they the same size as the side pieces? Thank you for being helpful. I'm making University of Michigan boards for my brother's birthday and yours are very impressive. By spraying the poly on are the boards to slippery? I know you said they come out having a glass finish which is awesome but I have played on some boards where the bags just fly off because they're too slippery.
Last question is do you use any wood glue to secure the plywood to the 5/4 x 4 pine boards or just the pocket holes? Also if you could give me a step by step process in how you attach the pieces of wood that would be awesome. You've been very helpful. Thanks again.
I've built a Detroit Lions cornhole board that came out so so. I have the K5 and tried to put the screws up like you did but went through the birch plywood. Just curious what settings you had on your kreg jig and what size screws you used? Did you use 1/2 inch birch or 5/8 inch birch. Also did you use 2 x 4's to go around or thinner wood? How many coats of polyurethane did you use on the top? Thanks.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service
You need to be a member of Kreg Owners' Community to add comments!
Join Kreg Owners' Community