Drill Press Table
-
Comment by Joseph M. on March 11, 2011 at 4:00pm
-
Gary, I centered the base onto the round steel table first by putting the back of the base flush with the edge of the steel table and centered it side to side. Then I just lined up the new table top onto the base with the back edge flush with the back edge of the base on center of the base.
Because the table can swivel around I didn't really 'square' it in that sense...if the table is moved from side to side I'll have reset the position visually with a drill bit chucked.
-
Comment by Gary roofner on March 11, 2011 at 3:34pm
-
Looks great. I bought one recently. What did you use for reference to square the table? I was think of putting a staight edge on back two holes and mounting a block to square with.
-
-
Thanks guys. The table size is 17" x 32" and is about 1" thick.
-
Comment by ron gagnon on March 11, 2011 at 10:58am
-
very nice looking table for drill press what size is it?
Need Help?
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
Popular Posts & Projects
Videos
Forum
Jig settings for 2 ¾ x 1 ½ boards with 30 degree miters?
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
40mm Cup Hinge Jig Question
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
Product Reviews
New Kreg 720Pro
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Not Pleased With Pocket Hole Construction
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep.
Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service
