Kreg Owners' Community

Rating:
  • Currently 0/5 stars.

Views: 874

Projects: Crate Storage Coffee Table
Favorite of 1 person

Comment

You need to be a member of Kreg Owners' Community to add comments!

Join Kreg Owners' Community

Comment by hertoolbelt on December 30, 2015 at 3:55pm

The top is made from 2x8 lumber and they come with a bevel on the edges.  I trimmed about 1/8" off from each side to get a straight edge to glue together, but didn't cut the bevel all of the way off (hope that makes sense).  No router, but on the end pieces, I used the sander to try and match the bevel on the side pieces.    

Comment by George Merkley on December 30, 2015 at 3:47pm

Thanks, I was wondering why there were "cut" pieces that didn't match the materials. Now it makes sense. That won't be a problem. 

I like that the table top pieces do not meet up flush, so there is a defined line between each. Did you "do" anything to make that happen (routing?).

Thanks for sharing.

Comment by hertoolbelt on December 30, 2015 at 2:52pm

Thanks George.  It is fairly easy to build.  I think the only tricky part for beginners is that I ripped the face frame boards down from 1x4's or 1x3's on the table saw. 

Comment by George Merkley on December 30, 2015 at 2:04pm

Hi, 

I am new to the community, this is my first official post. This is really beautiful, very nice job you did here. Would you say this was relatively easy? This might be my first project. 

Comment by hertoolbelt on February 21, 2015 at 4:17pm
I used Carrington by rustoleum or varathane
Comment by jon garrett on February 21, 2015 at 4:12pm

What color stain was used on the top?

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Concealed Hinge Jig Setting Confusion

The Kreg Concealed Hinge Jig has a setting for the distance from edge of the door to the nearest edge of the 35 mm cup hole. This can be set as 3, 4, 5, or 6 mm.Later in the instruction there is a table that converts the distance from the edge of…Continue

Started by Ken Kortch in Kreg Jig® Operation Oct 11.

Help with old Rip-Cut(tm)

I have an old Rip-Cut which I bought many years ago but did not set.  I seem to have lost the instructions, if I ever had them.I cannot figure out which bolts are match with the nylon-lock screws.This unit is old enough that the current instructions…Continue

Started by Sean in Other Kreg® Products Oct 4.

Product Reviews

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 1 Comment

Kreg Jig Dust Collection Attachment

1st impression when you hold this attachment in your hand:  "not much to it", Kreg sure is makin' $$ here.



Then I installed it.. perfect fit, leaves just enough room to adjust the setting screw on my K4.



Then the real test, hook…

Continue

Posted by Grampy Meyer on February 23, 2020 at 11:36am

© 2020   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_