Kreg Owners' Community

Rating:
  • Currently 0/5 stars.

Views: 217

Projects: China Hutch
Favorite of 1 person

Comment

You need to be a member of Kreg Owners' Community to add comments!

Join Kreg Owners' Community

Comment by Roger Bayne on December 31, 2015 at 3:20pm
I did not stain the wood, just applied multiple coats of home made wiping polyurethane.
Comment by Roger Bayne on December 31, 2015 at 3:19pm
Jim,
Thank you again for the compliments. I used White Oak on the entire hutch except the for the back. .
Comment by Conrad Johnson on December 31, 2015 at 1:28pm

what did you use for sides and top on base cabinet and also door panels , nice job 

Comment by Roger Bayne on May 21, 2015 at 2:13pm

Jim

Thank you for the very nice compliments. 

Comment by james wilhelm on May 21, 2015 at 2:07pm

Roger , very nice china hutch , great design and nice clean lines  on all the joints , also like the way you run the up rights in the the back middle section , set,s it off nicely , well done thanks for sharing , and happy wood working , JIM !!

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Concealed Hinge Jig Setting Confusion

The Kreg Concealed Hinge Jig has a setting for the distance from edge of the door to the nearest edge of the 35 mm cup hole. This can be set as 3, 4, 5, or 6 mm.Later in the instruction there is a table that converts the distance from the edge of…Continue

Started by Ken Kortch in Kreg Jig® Operation Oct 11.

Help with old Rip-Cut(tm)

I have an old Rip-Cut which I bought many years ago but did not set.  I seem to have lost the instructions, if I ever had them.I cannot figure out which bolts are match with the nylon-lock screws.This unit is old enough that the current instructions…Continue

Started by Sean in Other Kreg® Products Oct 4.

Product Reviews

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 1 Comment

Kreg Jig Dust Collection Attachment

1st impression when you hold this attachment in your hand:  "not much to it", Kreg sure is makin' $$ here.



Then I installed it.. perfect fit, leaves just enough room to adjust the setting screw on my K4.



Then the real test, hook…

Continue

Posted by Grampy Meyer on February 23, 2020 at 11:36am

© 2020   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_