Comment
Thanks Louis, and yes, a really good feeling to watch it all come together!
Thank you Rita, I also like the piece you recently posted you did a really amazing job on it. Doesn't make ya feel good when it comes out rite...
Hey Steve thanks for you're thoughts, well taken... w/ the door inserts I pre assembled to check for a really clean tight fit. I made the Dados a very tight precise fit using a good glue , I figure that joint will never come loose. I never use Bisquits any more. If you never used the mini jig I would highly recommend buying it , I works so well on thin small pieces and then plug it, It's a very clean finished look, you're like it and It's easy....
Great design and finish! The placement of the handles also draw the eye. Often times we tend to go dead center of the piece. You thought out this work excellently!
When I was looking at it...I was thinking the best way to do it was to attach the "ends" to the frame. Sure makes it easier in the long run. I've used Bisquits in the past, but I don't use them much anymore. They just don't hold like Screws and tite-bond 3 or a "good quality glue does". Look forward to seeing your next project.
I avoid front brads/staples where possible.
Thanks for the info. I like doing 1/2 lap myself. Works out great and it's pretty strong even with 3/4 board. I like gluing and running two 1/2 inch brads or staples on the back side just to hold it stronger and swipe the indent with a little stainable wood-putty. Keep up the good work.
Yes I did, and used the mini jig w/ 3/4 fine screws to attache it to the door frame & pluged every hole...
Did you use 1/2 lap/Dado grooves for the cross sections in the doors? Just curious.
Thanks for the nice comment on the cabinet... As for the propane tank you're referring to It is empty, but a good point well taken.. Thanks.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service
You need to be a member of Kreg Owners' Community to add comments!
Join Kreg Owners' Community