Kreg Owners' Community

Rating:
  • Currently 0/5 stars.

Views: 1165

Comment

You need to be a member of Kreg Owners' Community to add comments!

Join Kreg Owners' Community

Comment by Gary B. on November 18, 2010 at 5:32pm
yes. There are runners on the sides and rear and the shelves slide over the runners. The shelves are hollow. They are constructed with 3/4 inch plywood Top and bottom and a 3/4 inch solid wood front. To add more structural support to the shelf, there are 1 inch strips of solid wood pine that get glued to the top and bottom (inside the shelf). These strips are in deep enough inside the shelf so as not to interfere with the runners.
Comment by Joe Luberto on November 18, 2010 at 3:37pm
Thanx for that. Do the shelves fit over the runners, sorry for the questions, I'm new at this.
Comment by Gary B. on November 18, 2010 at 9:16am
yes the measurements are in inches. The top part of the page is the top view (as is indicated on the right). Looking at the front view, You have a 5.5 inch soffit, followed by 4 shelves. Then You have two drawers. Below the drawers is a radiator cover made of aluminum perforated sheets and spray-painted black.
Comment by Joe Luberto on November 18, 2010 at 7:50am
are the measurnments in in. What's the top part of the page,i think it's the top of the case. Can you give a better explanation. Jluberto@rogers.com Thanks Joe

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Jig settings for 2 ¾ x 1 ½ boards with 30 degree miters?

I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters.  What setting on the Jig should I used? 1 ½ is too much.  Thanks.Continue

Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.

40mm Cup Hinge Jig Question

Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue

Started by Ed Anderson in Beginners' Zone Oct 3, 2023.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…

Continue

Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments

© 2024   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_