Kreg Owners' Community

Wine Rack

Freestanding wine rack constructed of white oak. Rack was a gift for my sister and brother in law.

  • photo
  • photo
  • photo
  • photo
  • photo

Comment

You need to be a member of Kreg Owners' Community to add comments!

Join Kreg Owners' Community

Comment by Chip Fulkerson on September 20, 2014 at 6:29pm
This is the third one I have made . I haven't used plywood on any of them. So this is not a problem. But thanks for heads up. I live close to a Amish kiln so I get solid wood pretty reasonable.
Comment by Don Foley on September 20, 2014 at 11:26am

Chip,

If your building from the Wood magazine set of plans there's one thing to look out for.  I cut and assembled all pieces according to the plan and upon assembly the core of the plywood from the base is visible on the backside.  I think the plans should have called for the back to be 3/4" longer and the bottom 3/4" shorter.  that way the exposed edge of plywood would be facing down.  Since this one sits up against a wall I didn't feel a need to make a modification.

Hope this helps, Don

Comment by Chip Fulkerson on September 19, 2014 at 8:53pm
Nice. I'm building same one now. I am putting in the wine racks instead of shelves though.
Comment by michael evans on August 13, 2014 at 8:10am

Nice job on the wine rack Don ,be proud its a lovely job .

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Wall cabinet 14-16" deep

I'm looking for plans, especially the cutout pieces on a 4' x 8' sheet of plywood for wall cabinets that are deeper than the standard 12". Anyone in the community adapted Kreg plans for 12" to a deeper cabinet?Thanks, HenryContinue

Tags: cabinets, Wall

Started by Henry Beun in Kreg Jig® Projects Jul 25.

Joining 1.5" thick red oak butcher block

Hello. I am a beginner DIYer and new to this community. I am searching the best way for joining 1.5 inch thick Red Oak butcher block counter top. I need to join 2 boards perpendicular for L shape. Would 1 1/2 fine thread screws with 1 1/2  jig setup…Continue

Started by Aya Kaiho in Beginners' Zone Jul 17.

Product Reviews

Kreg Jig Dust Collection Attachment

1st impression when you hold this attachment in your hand:  "not much to it", Kreg sure is makin' $$ here.



Then I installed it.. perfect fit, leaves just enough room to adjust the setting screw on my K4.



Then the real test, hook…

Continue

Posted by Grampy Meyer on February 23, 2020 at 11:36am

My K4 Master System

I picked up the K4MS from Home Depot about 3 months ago, I was looking for a small filing cabinet for under my desk and nothing I looked at would fit or they wanted big money for it, my wife said “why don’t you just build your own then you will…

Continue

Posted by Randy W. Lush on August 25, 2019 at 12:30pm

© 2020   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_