Kreg Owners' Community

60 inch Bath Vanity

A 60 inch Bath Vanity I designed and built for my daughter and son in law. The top is a simple white man made material, the faucets are Moen. They were purchased from Lowes. The wood is cherry and it is sealed with Minwax Polycrylic, no stain was used as cherry wood will darken with age. Most of the assembly was done with Kreg pocket screws.

  • photo
  • photo
  • photo

Comment

You need to be a member of Kreg Owners' Community to add comments!

Join Kreg Owners' Community

Comment by Michael Ross on March 7, 2016 at 8:00pm

Thanks for the info. Great job on the vanity. Doing a cherry beaded face frame myself.

Comment by Frank Becker on March 7, 2016 at 12:36pm

 Euro style concealed hinges Liberty Hardware HC11SJC-NP-C5

Comment by Michael Ross on March 7, 2016 at 11:50am

What hinges did you use for the inset doors?

Comment by Frank Becker on August 5, 2015 at 5:04pm

A detailed set of plans for this Vanity is now available at Kregs BuildSomething website (www.buildsomething.com).

Comment by Jerry on April 21, 2015 at 9:37am
Very nice work, I may have to see if I've got the skills for this type of project.
Comment by Frank Becker on July 29, 2014 at 11:31am

Here is a close up of the beading detail.

Comment by Frank Becker on July 29, 2014 at 11:31am

Comment by KregRep on July 29, 2014 at 10:03am

Very nice work Frank. Thanks for sharing. The cherry looks great and will get even better as it darkens down over time.

KregRep

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Drawer Slide Jig - How to fit bottom drawer? 2 Replies

Hi guys.I'm probably being really stupid here, but I cant see any way to use the drawer slide jig to fit the bottom drawer of a set?I actually have a couple of questions:Firstly, should the drawer slide fit flush with the bottom of the drawer?(That…Continue

Started by Craig in Beginners' Zone. Last reply by Craig 8 hours ago.

Combination Pocket Hole and Tongue & Groove Joint

All material is 3/4"Tongue & groove is 1/4" tongue into a 1/4" grooveMy thinking is to set the jig and bit as though I was using 1" stock.  Use the screw called out for 3/4" material.  Is my thinking correct.ThanksGeorgeContinue

Started by George in Beginners' Zone Jun 13.

Product Reviews

Kreg Jig Dust Collection Attachment

1st impression when you hold this attachment in your hand:  "not much to it", Kreg sure is makin' $$ here.



Then I installed it.. perfect fit, leaves just enough room to adjust the setting screw on my K4.



Then the real test, hook…

Continue

Posted by Grampy Meyer on February 23, 2020 at 11:36am

My K4 Master System

I picked up the K4MS from Home Depot about 3 months ago, I was looking for a small filing cabinet for under my desk and nothing I looked at would fit or they wanted big money for it, my wife said “why don’t you just build your own then you will…

Continue

Posted by Randy W. Lush on August 25, 2019 at 12:30pm

© 2020   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_