Kreg Owners' Community

Comment

You need to be a member of Kreg Owners' Community to add comments!

Join Kreg Owners' Community

Comment by Roger Bayne on January 8, 2020 at 9:21am

Bobby

The wood is Eastern Red Cedar I purchased in Tennessee. I did use the kreg pocket hole jig for some joints. However for the screws I actually used desk screws that would not rust or mar the wood. 

Comment by Bobby on January 7, 2020 at 4:51pm

And what type of wood is that?

Comment by Bobby on January 7, 2020 at 4:46pm

Did you use a Kreg jig for this or did you do exposed brass screws like the plans state?

Comment by Roger Bayne on January 4, 2016 at 9:20am

Ben,

The plans I used are from D. Roy Woodcraft -https://www.google.com/url?sa=t&rct=j&q=&esrc=s&sou...;

The plans state that I cannot pass them along but they do not restrict me from sharing the downloadable link.

Comment by Roger Bayne on December 31, 2015 at 4:00pm

Benjamin,

I have plans for these chairs and will located them as soon as I have an opportunity.

Comment by Zen Diesel on December 30, 2015 at 3:46pm

Nicely done! 

Comment by Roger Bayne on September 30, 2015 at 9:26am

I can only share the link where I got the original plans. I have customized them a bit to fit my needs, but nothing drastic.

http://content.jettools.com/content/jet50/wood/freebies/jet50_adiro...

Comment by Benjamin Facer on August 25, 2015 at 12:27pm

Are there plans on this site for the adirondack chair?

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Accu-Cut XL track alignment issue 1 Reply

Hi All,I'm just wondering if anyone else has had this issue and can help me,I recently purchased the Accu-Cut XL and when I went to put the track together I noticed that one of the tracks was different to the others The alignment of the track guide…Continue

Started by Al Barale in Community-Specific. Last reply by KregRep on Tuesday.

Advice on assembling the "offset" bottom of a wall cabinet

Hi,I'm about to build my first wall cabinet, using 3/4 plywood for the box and 1x2s for the face frame. Everything will be assembled using pocket hole joinery. I've attached a basic image of what the cabinet box will look like.I'm planning to have…Continue

Tags: cabinet, holes, pocket

Started by Jeff Welsh in Beginners' Zone May 26.

Product Reviews

Kreg Jig Dust Collection Attachment

1st impression when you hold this attachment in your hand:  "not much to it", Kreg sure is makin' $$ here.



Then I installed it.. perfect fit, leaves just enough room to adjust the setting screw on my K4.



Then the real test, hook…

Continue

Posted by Grampy Meyer on February 23, 2020 at 11:36am

My K4 Master System

I picked up the K4MS from Home Depot about 3 months ago, I was looking for a small filing cabinet for under my desk and nothing I looked at would fit or they wanted big money for it, my wife said “why don’t you just build your own then you will…

Continue

Posted by Randy W. Lush on August 25, 2019 at 12:30pm

© 2020   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_