For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
Hi guys.I'm probably being really stupid here, but I cant see any way to use the drawer slide jig to fit the bottom drawer of a set?I actually have a couple of questions:Firstly, should the drawer slide fit flush with the bottom of the drawer?(That…Continue
Started by Craig in Beginners' Zone on Sunday.
All material is 3/4"Tongue & groove is 1/4" tongue into a 1/4" grooveMy thinking is to set the jig and bit as though I was using 1" stock. Use the screw called out for 3/4" material. Is my thinking correct.ThanksGeorgeContinue
Started by George in Beginners' Zone Jun 13.
1st impression when you hold this attachment in your hand: "not much to it", Kreg sure is makin' $$ here.
Then I installed it.. perfect fit, leaves just enough room to adjust the setting screw on my K4.
Then the real test, hook…
Posted by Grampy Meyer on February 23, 2020 at 11:36am
I picked up the K4MS from Home Depot about 3 months ago, I was looking for a small filing cabinet for under my desk and nothing I looked at would fit or they wanted big money for it, my wife said “why don’t you just build your own then you will…Continue
Posted by Randy W. Lush on August 25, 2019 at 12:30pm