Kreg Owners' Community

Rating:
  • Currently 0/5 stars.

Views: 381

Comment

You need to be a member of Kreg Owners' Community to add comments!

Join Kreg Owners' Community

Comment by Tito Comas on October 19, 2017 at 1:10pm

See, I am not the only one admiring your craftsmanship Andy!!

I just looked up the Essential hardware website, man they have a lot of products. Was there a category under which the legs you made were found? Did you buy the corner brackets there as well?

Tito

Comment by Andy Wilson on April 17, 2017 at 9:45am

Oh yeah - I used Weldwood Contact Cement to glue the vinyl to the box pieces before I built the box. This glue is perfect for this application. It would work on felt of canvas as well.

Comment by Andy Wilson on April 17, 2017 at 9:43am

Sure - I just kinda did it by the seat of my pants. I'll see what I can put together for you.

But just as a starter-
 The box is 25 1/2 x 110 so it would fit the wall. The bottom of the box is 1 1/2 in thick to prevent warping, etc.

 I used standard 5 1/2 width common pine to give it a rustic look.

 The inside of the box is vinyl - I pinched the ends into the box joins.
 The paying surface is stained birch plywood (1 1/2 thick) with about 8 coats of poly, I ended up making a new playing surface using no stain b/c my water-slide number decals didn't show up on the dark stain.

I got the legs from Essential Hardware . com. 

Comment by Ethan Schmidt on April 17, 2017 at 12:06am

Wondering if you are willing to share the plans for this project? Also great job I think this turned out amazing.

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

This has nothing to do with woodworking 1 Reply

I am trying to add some shelves in my grandchildren's bedroom. The wood shelving is held up by brackets which are installed into vertical racks installed in the walls. I need to purchase the brackets, but I have no idea what you call the piece. I…Continue

Started by Michael Meyer in Beginners' Zone. Last reply by Mike Hensel Aug 16.

Wall cabinet 14-16" deep

I'm looking for plans, especially the cutout pieces on a 4' x 8' sheet of plywood for wall cabinets that are deeper than the standard 12". Anyone in the community adapted Kreg plans for 12" to a deeper cabinet?Thanks, HenryContinue

Tags: cabinets, Wall

Started by Henry Beun in Kreg Jig® Projects Jul 25.

Product Reviews

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 1 Comment

Kreg Jig Dust Collection Attachment

1st impression when you hold this attachment in your hand:  "not much to it", Kreg sure is makin' $$ here.



Then I installed it.. perfect fit, leaves just enough room to adjust the setting screw on my K4.



Then the real test, hook…

Continue

Posted by Grampy Meyer on February 23, 2020 at 11:36am

© 2020   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_