I am going to build large planter boxes for our yard. I am planing on using 1 inch cedar boards anr 2x2 inch corners posts. I need to know what thread pitch and driver detting to use.
Thanx
Mike
Tags:
On cedar I would be inclined to go coarse thread. Driver setting, start about 1/3 of the way up the scale and increase a notch or two at a time until the joint pulls tight. Best I can do there on the info you gave.
I would recommend stainless screws though.
I use regular screws if they are not seen by eye ball just putty them up so no moisture gets to them ,If you do that body putty will work for you just fine
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I've been using my Adaptive Cutting System table for a few years now, and it's been really solid. This past week was the first time I ever needed to use the miter guide though.I was rebuilding some shelving in a tiny closet and I discovered the…Continue
Tags: ACS
Started by Adam in General Woodworking May 6.
I am building a small trunk for a military friend to put some belongings in. I have made legs out of ash hardwood and will make the sides out of 1/2” or 3/4” Baltic birch plywood. The legs are 1.5” thick by 2” wide. So since I’m drilling pockets in…Continue
Started by Mike Bohannon in Beginners' Zone. Last reply by Jay Boutwell Apr 19.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2022 Created by KregRep.
Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service