Kreg Owners' Community

I am thinking about getting a Kreg and was wondering what is the first thing i need to get started and try and see if i like it. 

Views: 472

Reply to This

Replies to This Discussion

Depends on what kind of project you are planning to build.

Hi Robert,  If you are just getting started the first thing you need is a method to cut lumber in a square and accurate way to produce flat 90 degree angles.  This can be done using a hand saw and a simple miter box. 

 You will need a 3.8 electric drill  either  a corded one or a battery drill that will have enough power to turn a 3/8 " drill bit.   This is the step drill bit from the kreg jig set.  You will need a simple tape measure and a small square to check  your material  to see if it is square.  Then you will need a beginners basic kreg jig pocket hole set.   Begin with 3/4" lumber like pine that is easy to cut and drill and some  1 & 1/4" kreg screws.

This will get you started to cutting and fitting pocket holes. 

You will also need a couple hours to get you addicted. 

Robert, you can also check out your local woodworking shop. Many of them have small areas where you can try things out. I live near the Woodsmith Store. They have a small area with Kreg products. Your local store may have something so that you can check it out. You can also get the small kit and see if you like it. Then go from there. I hope this helps.

Hope this helps! Thank you for your interest in Kreg products!
KregRep

I'm looking to buy one as well, the K4 MS or the K5.  Suggestions?!

 

Thanks..........Kent

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Pantry slides for heavy application

  Recently purchased two 96" tall pantry cabinets that are 23" deep that only came with two adjustable shelves and two fixed, (one at about 55" and one at the very bottom).  Shelf holes in the walls are drilled 2" O.C.  Like most store-bought…Continue

Tags: drawer, slides, pantry, pull-out, 75-Lb

Started by Paul Coon in General Woodworking Aug 11.

Miter Saw Recommendation 1 Reply

I’m looking to upgrade my miter saw. I’m willing to invest a good amount of money to get one with the precision pocket hole joinery requires. Would anyone like to offer a recommended model?

Started by Joe Racz in Beginners' Zone. Last reply by Scott Davison Oct 6.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…

Continue

Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 8 Comments

© 2021   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_