I am in the process of building a bathroom vanity out of oak. I am wondering which screws to use or which woud be better to use Washerhead or the Panhead.
Thanks in advance for your comments.
Greg
Tags:
Personally, I prefer the washerhead. I've had very little success with the Panhead so i don't use them. However, i also tend to work mostly with plywood....That may make a difference (wood density?)...you might have better luck with them since you're working with Oak and not plywood.
You'll be using the fine thread regardless of which screw you use.
Greg, I agree with geoff .
Geoff and Ray, thanks for your advice. It is solid oak I won't be using any plywood at all. I purchased some wel alot of 6in 3/4 oak matched tongue and groove oak. I couldn't pass it up its also stained and pre-finished for an unbeleivable price of $300 measured it all up called the local lumber company for a quote on what I purchased and they gave me a price of $2300. Sorry for being long winded but had to tell the story. Would you also recomend glueing also? It's going to be a more or less mission style vanity. Again thank you for your fast input.
Greg
Hi Greg, That didn't sound like you were long winded, It sounded like you were bragging, Way to go that's one hell of a deal
Mike and David, thanks for your response I will be going with the washer heads. This is a very informative forum. Taking on a BIG first project, and this has helped me make a decision.
Thanks.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service