Kreg Owners' Community

Using pocket holes on 45 degrees connection for table frame

Hi all, new member here.

I am making a table and for the frame I want to use short braces connecting at 45 degrees to the frame's sides. Those braces will connect to the table's legs.

I don't want to use the jig just to the end of the 45 degrees angle because there is not enough "meat" to use doing it from the outside while there is no access from the inside.


See the source image

The picture shows such a brace, with screws that may or may not be pocket.

I will need to offset the jig in order to get the best "grip".

Are there any recommendations?

Thanks in advance.

Views: 891

Attachments:

Reply to This

Replies to This Discussion

Zvi, 

You can use pocket holes for this application.  Unfortunately there is not a standard setup for it.  Depending on the thicknesses of both your support piece and that of the apron your settings will change.  The best option would be to set everything up for the thinner thickness of the two and use some scrap pieces to find the best length of screw to use to give you the most holding power.  

I'm sorry but this is a wonderful non-reply.

I ended up drilling without the jig.

The jig gives me a 15 degrees hole.

Instead I drilled at 45 degrees to the brace (perpendicular to the 45 degrees edge).

I think that this will give me good strength of connection while allowing for a (relatively) shorter screw or hole.

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Pantry slides for heavy application

  Recently purchased two 96" tall pantry cabinets that are 23" deep that only came with two adjustable shelves and two fixed, (one at about 55" and one at the very bottom).  Shelf holes in the walls are drilled 2" O.C.  Like most store-bought…Continue

Tags: drawer, slides, pantry, pull-out, 75-Lb

Started by Paul Coon in General Woodworking Aug 11.

Miter Saw Recommendation 1 Reply

I’m looking to upgrade my miter saw. I’m willing to invest a good amount of money to get one with the precision pocket hole joinery requires. Would anyone like to offer a recommended model?

Started by Joe Racz in Beginners' Zone. Last reply by Scott Davison Oct 6.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…

Continue

Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 8 Comments

© 2021   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_