I built a small table for one of my "Weekend Projects" on Extreme How-To.
The legs had two sides that were flat and the other two continued the curves of the lower portion. I used the two flat sides and my Kreg Jig to attach the 1x4s between the legs.
The legs were purchased at Lowe's precut oak. The table top was a stock poplar size and the remainder of the lumber was oak, bought in sizes close to those needed for the long and short sides of the table top.
The project was a simple one. However, next time I will avoid Poplar though as I had an issue with profiling its edges.
What are other ways I could use the Kreg Jig with curved parts? Weekend Projects is meant to be simple. The Kreg Jig keeps joinery very simple, but what are the best ways to use it on legs and other parts that have curves?