Kreg Owners' Community

Hello All:

I am building a storage unit to hold six large Rubbermaid tubs.  It will essentially be a large box with one vertical divider and horizontal shelves.  Basicly, it will look like the image I have attached.

Am I better off to construct it with the shelves as two pieces and one single vertical divider or should the shelves be one piece each and the vertical support as three sections?  I will use 3/4" plywood with a face frame & a masonite back panel.  Should I add extra support under the shelves so that they won't bow?  The Rubbermaid tubs are about 24" X18"X 24".

Thanks

Views: 110

Attachments:

Reply to This

Replies to This Discussion

It depends on how U R going to fasten the shelves? R U going to put dado in the vertical peace for the shelves to sit in? Or R U going to use pocket holes if so I would recommend U put a cleat under the shelve for a little more support. Or U can do what Jame recommended but I would still put a cleat or dado on the out side vertical peace for supporting heavy loads
I built something similar and found that if you use 2x4s for the face frame and the Kreg jig it will hold about anything that will fit into the tub. And after seeing how strong it is I wouldn't even put the vertical divider in there. If it will just be the width of two tubs. Just add support midway under the shelf with pocket holes. Oh, and I set the plywood on top of the supports and didn't use pocket holes in the plywood itself. It is very solid!

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Rip-cut ACS plunge saw

Just got a rip-cut and installed my Bosch saw haven't used it yet but saw was a good fit. Got the original ripcut and didn't really like it had trouble cutting straight. New one has several improvements should make it work much better. especially…Continue

Started by William Burt Brown in General Woodworking Mar 17.

Is the screw driver impact drill rater?

Is the screw driver impact drill rated?Continue

Started by Bob Naylor in Beginners' Zone Mar 10.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…

Continue

Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 4 Comments

© 2021   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_