Round Table Top - Kreg Owners' Community2024-03-29T15:00:56Zhttps://kregjig.ning.com/forum/topics/round-table-top?feed=yes&xn_auth=noHi Jim I'm from dracut also i…tag:kregjig.ning.com,2010-03-23:2900167:Comment:275932010-03-23T15:43:32.898ZJeffrey Pikehttps://kregjig.ning.com/profile/JeffreyPike
Hi Jim I'm from dracut also if U need a hand I would be glad to help U out. I made a round table out of cherry and I made a circle cutting jig to cut out a 6' round table.
Hi Jim I'm from dracut also if U need a hand I would be glad to help U out. I made a round table out of cherry and I made a circle cutting jig to cut out a 6' round table. Lowes' has a magazine which s…tag:kregjig.ning.com,2010-03-23:2900167:Comment:275832010-03-23T15:12:09.807ZJens Jensenhttps://kregjig.ning.com/profile/JensJensen
Lowes' has a magazine which showed trimming a round table but it was not KPH just curfed plywood and bent it around. I try get article and send it to you if you want
Lowes' has a magazine which showed trimming a round table but it was not KPH just curfed plywood and bent it around. I try get article and send it to you if you want Ok here"s how I would do it m…tag:kregjig.ning.com,2010-03-23:2900167:Comment:275432010-03-23T05:31:26.587ZWalter_larshttps://kregjig.ning.com/profile/Walterlars
Ok here"s how I would do it make a router jig with a long enough base so that you can get the radius you need at least 24" for a 48" diameter table use the same jig to cut the out side trim pieces out of flat boards make sure the trim pieces are wide enough to accept a PH<br />
lay out your project full size on a piece of paper to find the miter angles for your trim pieces
Ok here"s how I would do it make a router jig with a long enough base so that you can get the radius you need at least 24" for a 48" diameter table use the same jig to cut the out side trim pieces out of flat boards make sure the trim pieces are wide enough to accept a PH<br />
lay out your project full size on a piece of paper to find the miter angles for your trim pieces