Tags:
I understand what Larwyn is saying and he is correct. Just because the wood parts "seem" the same doesn't make it so. The thickness planer makes a big difference on how well the clamps work.
That said: You can advance the screw a bit so that the point is exiting the pocket a little bit then you clamp and the shift or creep will be less. Sort of like having a sharp tack holding the wood until the screw is in place.
Then again you may have to tell the wife how important a new planer will be and the clamping table is an absolute must, and don't fail to mention how much money new cabinets are going to cost if someone else make them, and . . . This forum has a wealth ofrationalizationsreasons to help our brother woodworkers stock their shop! :-)
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service