Kreg Owners' Community

On an end table I am joining 3/4", 4 1/2" wide aprons to a 1 3/8" square leg.  Material is Red Oak.  Is it best practice to vertically position the pocket holes differently on one apron so the pocket screws do not interfere with each other when driven into the leg?  Any suggestions on how much I need to position them Or do I not need to be concerned about this?

Thanks, Dick

Views: 1526

Reply to This

Replies to This Discussion

I'm not an expert by far but I'd probably try to use 3 or maybe 4 shorter screws to join to the square leg. You can always use a piece of scrap to see how far the different screw lengths penetrate into the legs. Good luck
Hi Dick,
I am on my second furniture project as well as my second using the Kreg jig, I admit being a novice. I did not pre-plan the locations of the pocket holes on the first project, as a result I had screw interference, first where the aprons attached to the leg, second where the top attached to the aprons, both situations required relocating some pocket holes. In addition I had routed slots in the legs for the 1/4" plywood side panels, in this case I had to use 1-1/2" screws to get past the slot, next time I will not route the slot where the aprons attach.
In my case I learned the importance of pre-planning the pocket holes the hard way.
Thanks for the replies. I think I will spend some time looking at vertically positioning the pocket holes on the back apron differently than they are positioned on the side aprons. Since the front contains a drawer there are two 1" rails instead of aprons where currently I am thinking tenon joinery. If you have the Anthony Guidice book "Tables" [purchased at Rockler , isbn1-56158-342-1]. I am working with his cover design project which is detailed on page 33. Of course there will be differences in my project as there always are ;-).

Dick

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Pantry slides for heavy application

  Recently purchased two 96" tall pantry cabinets that are 23" deep that only came with two adjustable shelves and two fixed, (one at about 55" and one at the very bottom).  Shelf holes in the walls are drilled 2" O.C.  Like most store-bought…Continue

Tags: drawer, slides, pantry, pull-out, 75-Lb

Started by Paul Coon in General Woodworking Aug 11.

Miter Saw Recommendation 1 Reply

I’m looking to upgrade my miter saw. I’m willing to invest a good amount of money to get one with the precision pocket hole joinery requires. Would anyone like to offer a recommended model?

Started by Joe Racz in Beginners' Zone. Last reply by Scott Davison Oct 6.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…

Continue

Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 8 Comments

© 2021   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_