Kreg Owners' Community

Gentlemen and Ladies,

 

I am headed off to the lumber yard in the morning to pick up the necessary wood to build my first Kreg project.  It is the small bookcase.

 

I've been to Lowes and Home Depot in search of the wood.  I found hardwood plywood in 3/4 and 1/4 sizes in Oak and Birch.  However, I can only find Red Oak, Pine, Aspen, and Poplar to use as the "face frame" material.

 

I like the look of the Birch plywood and that would be my choice.  My question is this ..... can I mix the other "face frame" woods with the birch (and will it look ok) or should I just switch to Oak for the whole project.

 

This may sound silly, but I'm not sure how each of the different woods will take the stain and I want this to look good when it's done.

 

Thanks.

Views: 267

Reply to This

Replies to This Discussion

Each of the woods take the stain in a lot different way. If you are going with a darker color, you should be able to mix the birch and the red oak, but if you are going for a ligher color stain I would stick to the same wood thoughout the project.
Red oak needs a filler because of its pour's and would look noticeably different than Birch. Pine is soft and blotches when stained unless treated with a sealer. If you can not find Maple which I believe would do what you want, use the poplar but try to keep out most of the green dark wood. Poplar stains well . I use a-lot of Black Walnut in my projects, and I use the Poplar when plywood is needed because it has the grain of Walnut and takes walnut stain very good. For a better Idea of what you want to use stain up some samples to assure the match.
Well, as luck would have it, I went to a different lumber yard (SUTHERLANDS) and found Birch plywood in my 2 required dimensions and also found MAPLE for all the "face frame" type stuff. And I saved about $15.00 vs. the pricing at Lowes.

That's what I purchased and I do plan to "test stain" some of my "left-over" materials to get an idea of how it will look when assembled.

Thank you all for your suggestions.

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Rip-cut ACS plunge saw

Just got a rip-cut and installed my Bosch saw haven't used it yet but saw was a good fit. Got the original ripcut and didn't really like it had trouble cutting straight. New one has several improvements should make it work much better. especially…Continue

Started by William Burt Brown in General Woodworking Mar 17.

Is the screw driver impact drill rater?

Is the screw driver impact drill rated?Continue

Started by Bob Naylor in Beginners' Zone Mar 10.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…

Continue

Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 4 Comments

© 2021   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_