Kreg Owners' Community

Any recommendations on how to attach a K4 or K5 Jig to a Mobile Project Center? What hardware should be used?

Views: 3779

Reply to This

Replies to This Discussion

Glenn, 

The Mobile Project Center has mounting holes in the top allowing you to fasten your jig securely. All you will need are some 10-32 machines screws and nuts to hold it in place. There are nut retainers on the bottom of the table that will enable you to easily tighten your jig in place. If you have any other questions, please let us know.  

Thank you!

Here is how I mount my k3.

Attachments:

seems like it should have been designed to be fastened with at least the kreg clamps. I store my K5 in the storage case.

Why in the world didn't y'all include this information in the manual? Seems odd to me. 

Thanks for the info.

KregCS said:

Glenn, 

The Mobile Project Center has mounting holes in the top allowing you to fasten your jig securely. All you will need are some 10-32 machines screws and nuts to hold it in place. There are nut retainers on the bottom of the table that will enable you to easily tighten your jig in place. If you have any other questions, please let us know.  



Aaron Schrank said:

Why in the world didn't y'all include this information in the manual? Seems odd to me. 

Thanks for the info.

+1

There is no right or wrong way to install.

What is the Mobile Project Center? Please include photo if possible.

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Accu Cut 1 Reply

All of my cuts are slightly beveled.  I am leaning on saw in one direction to keep it tight because it feels like there is a tiny bit of looseness in the saw sled at the rear.  I don't have this problem with the Accu Rip and the same sled.  Had to…Continue

Tags: sled, saw, slop, cut, Accu

Started by Debby Rouchon in Beginners' Zone. Last reply by KregRep Feb 20.

Loft Bed

Ok, just to let you know. I don't know one end of a bit of wood to the other !I need to build a loft bed for my 14yr old daughter for her new small room.would 30X70mm be large enough to make it out ofThanks for any inputPS anyone got any plansContinue

Started by Chris Taylor in Beginners' Zone Feb 10.

Product Reviews

Kreg Jig Dust Collection Attachment

1st impression when you hold this attachment in your hand:  "not much to it", Kreg sure is makin' $$ here.



Then I installed it.. perfect fit, leaves just enough room to adjust the setting screw on my K4.



Then the real test, hook…

Continue

Posted by Grampy Meyer on February 23, 2020 at 11:36am

My K4 Master System

I picked up the K4MS from Home Depot about 3 months ago, I was looking for a small filing cabinet for under my desk and nothing I looked at would fit or they wanted big money for it, my wife said “why don’t you just build your own then you will…

Continue

Posted by Randy W. Lush on August 25, 2019 at 12:30pm

© 2020   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_