Kreg Owners' Community

I'm thinking about mounting a flat screen on my wall.  Problem is I have plaster & lathe walls.  Here's my plan.  Mount a 3/4" plywood backer board using 3" lag bolts to the studs big enough to securely hold the wall mount bracket.  Mount the bracket to the backer board using many, many 1 1/2" lag bolts.  Thoughts? 

Views: 670

Reply to This

Replies to This Discussion

Brian I see nothing wrong with your plan.  The problem with lath and plaster walls is that the laths are attached to the wall studs with small nails making the laths very brittle and easy to let go of the wall studs.  The plaster is attached by the plaster that passes between the laths and when it becomes dry it bonds itself to the laths.  Over time it becomes brittle and becomes loose.  This makes the plaster unsuited to hold anything that weight much over 5 to 10 lbs.  It is also not a very good anchor point for attaching your plywood.  If bridging multiple wall studs with a 3/4 inch thich piece of plywood you will get most of your holding power by lagging into the wall studs themselves.  The studs should be between 16 and 18 inch centers however may be as wide as 24" depending on who built the wall.   I would recommend spanning of at least 3 studs if possible but here again it will depend on the weight of you TV.  I worse cases I would open the area behind the intended TV placement and maybe add some additional support. 

Since the TV is held by two brackets, if you can fit it in a location where both brackets are screwed into the wall studs I would think that would sufficient. 

Hi Jay.  Thanks for the reply.  I like the idea of opening the wall and adding more support.  That way I could build 2x4 supports in the wall to secure the wall mount.

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Replacing existing slides but cannot remove drawer front

The Kreg slides are made to work with new drawers before putting on the drawer front. In my situation, I cannot remove the existing fronts which means when reversing the jig to hold the draw, it’s at an angle. Not sure what I should do to make them…Continue

Started by Jay Homeyer in General Woodworking Apr 25.

Parts

The Clamp anchor screw broke on my mobile project center.  How can I acquire a replacement?Continue

Started by Jon J Howard in Beginners' Zone Apr 20.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…

Continue

Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 4 Comments

© 2021   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_