Kreg Owners' Community

Our friends at Woodworkers Guild of America recently published a video we thought some of you may enjoy: Making a Drawer Lock Joint. It features the new Kreg Precision Router Lift

Drawer lock joints made using a drawer lock router bit are a great way to put drawers together. Once the setup is right the joint can be cut very fast, and the mechanical interlock the joint provides makes it very strong. 

For a drawer lock joint to fit correctly, the height of the bit and the fence position must both be perfect. If either one is off, you’ll have a lousy fit, which compromises the joint. They go over this and more in the video

Views: 1287

Reply to This

Replies to This Discussion

That bit can be fussy to set up unless you have a micro dial. Otherwise it does a great job. Very strong joint.

Once you get the bit height dialed in, make a setup block in order to speed up next time you use the bit. Saves a lot of time and headaches.

I have the setup block that came with the bit. It works great but I don't have a micro dial to tune it finely.

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Accu Cut 1 Reply

All of my cuts are slightly beveled.  I am leaning on saw in one direction to keep it tight because it feels like there is a tiny bit of looseness in the saw sled at the rear.  I don't have this problem with the Accu Rip and the same sled.  Had to…Continue

Tags: sled, saw, slop, cut, Accu

Started by Debby Rouchon in Beginners' Zone. Last reply by KregRep Feb 20.

Loft Bed

Ok, just to let you know. I don't know one end of a bit of wood to the other !I need to build a loft bed for my 14yr old daughter for her new small room.would 30X70mm be large enough to make it out ofThanks for any inputPS anyone got any plansContinue

Started by Chris Taylor in Beginners' Zone Feb 10.

Product Reviews

Kreg Jig Dust Collection Attachment

1st impression when you hold this attachment in your hand:  "not much to it", Kreg sure is makin' $$ here.



Then I installed it.. perfect fit, leaves just enough room to adjust the setting screw on my K4.



Then the real test, hook…

Continue

Posted by Grampy Meyer on February 23, 2020 at 11:36am

My K4 Master System

I picked up the K4MS from Home Depot about 3 months ago, I was looking for a small filing cabinet for under my desk and nothing I looked at would fit or they wanted big money for it, my wife said “why don’t you just build your own then you will…

Continue

Posted by Randy W. Lush on August 25, 2019 at 12:30pm

© 2020   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_