Kreg Owners' Community

HI, all.

Building a large pantry.  The shelves in the rear of the pantry are 10" wide.  Followed by a swinging 8" shelf system.  What is the easiest way to set my front pin holes with the jig.  Obviously, there is no edge or lip in the middle of the panel.   The holes to the back can be done normally, how can I set for the front holes? 

Hope this is some what clear...

rstandi

Views: 379

Reply to This

Replies to This Discussion

Hi Rod, about the most accurate method would be to use a framing square and determine a straight and square line off the back of the cabinet.  If you do not want to mark a line on the surface of the cabinet then use tape such as painters tape and use the edge as a you would a pencil line. 

 Short of using the shelf pin guide you could use an old trick that I have often used on odd places, and use a piece of squared up peg board.  use the front of the cabinet to square it up and use the  peg holes as a template.  They are evenly spaced and make a quick solution to your type of problem.

Hi Rod, I sometimes use a piece of scrap plywood cut at a starting height from the bottom of the cabinet to get my holes to line up. you could use the same tactic for front to back to keep your jug on track.

Gonna try the my circular saw cutting jig.  It's straight and then the jig up against that.

Thanks for your replies

Rstandi

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Pantry slides for heavy application

  Recently purchased two 96" tall pantry cabinets that are 23" deep that only came with two adjustable shelves and two fixed, (one at about 55" and one at the very bottom).  Shelf holes in the walls are drilled 2" O.C.  Like most store-bought…Continue

Tags: drawer, slides, pantry, pull-out, 75-Lb

Started by Paul Coon in General Woodworking Aug 11.

Miter Saw Recommendation

I’m looking to upgrade my miter saw. I’m willing to invest a good amount of money to get one with the precision pocket hole joinery requires. Would anyone like to offer a recommended model?

Started by Joe Racz in Beginners' Zone Jul 22.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…

Continue

Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 8 Comments

© 2021   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_