Kreg Owners' Community

Look for owner feed back on the Kreg router table, self squaring fence and lift. Look to purchase one as it has some very cool features. The lift looks to be will though out. But since all the local Kreg dealers just stock the Pocket Hole tools I can not touch and feel it or even just buy it. 

So anyone how has first hand knowledge of the Table, fence and or List would be greatly appreciated.

Views: 5180

Reply to This

Replies to This Discussion

My bad, I thought you had the table top model.

Below are some photos of my Kreg router table setup today, some six years later. I add some drawers and some dust collection. The one photos with the black tube, is inside the dust collection box. The white tube, that is cut into the black tube, provides suction pickup for the fence.  The collection extends down below the blue rails. 


This shows the main 4" vacuum line and the smaller suction line going up to the fence
This is a picture inside the dust collection box. the black tube is the 4" suction line from the cyclone. The white tube, that is cut into the black tube is the suction pick up for the fence
Bottom of dust collection box.


Looking inside the dust collection box. Router motor at top of photo.

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Concealed Hinge Jig Setting Confusion

The Kreg Concealed Hinge Jig has a setting for the distance from edge of the door to the nearest edge of the 35 mm cup hole. This can be set as 3, 4, 5, or 6 mm.Later in the instruction there is a table that converts the distance from the edge of…Continue

Started by Ken Kortch in Kreg Jig® Operation Oct 11.

Help with old Rip-Cut(tm)

I have an old Rip-Cut which I bought many years ago but did not set.  I seem to have lost the instructions, if I ever had them.I cannot figure out which bolts are match with the nylon-lock screws.This unit is old enough that the current instructions…Continue

Started by Sean in Other Kreg® Products Oct 4.

Product Reviews

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 1 Comment

Kreg Jig Dust Collection Attachment

1st impression when you hold this attachment in your hand:  "not much to it", Kreg sure is makin' $$ here.



Then I installed it.. perfect fit, leaves just enough room to adjust the setting screw on my K4.



Then the real test, hook…

Continue

Posted by Grampy Meyer on February 23, 2020 at 11:36am

© 2020   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_