Tags:
I know your still getting to together, but whats your thoughts on the fence and table so far? I'm looking at buying them also... Once I get the base built....
Greg, was that mistake due to the isntructions? I've been thinking about gettin the smaller model this Fall if possible. Not enough room in my shop for a full-size. How oes quality compare to the Kreg Jig?
Here is a photo of the huge Porter Cable 7518 Router bolted up to the Kreg Precision Router Table Lift. The 7518 is a very large and heavy router motor. One nice thing, about the 7518, is you can buy a "Motor Replacement" instead of the whole router. That saves you at least $50.
Greg, you may have answered my question in your post but let me make sure of that. I don't have room in my shop for the full size Kreg router table and will purchase the portable or table top model. Is it possible to add the better t-square style Kreg fence to the table top model down the road?
Not sure as I do not have a table top unit. I would assume it would take some DIY modifications as the table top unit has a smaller top.
Not sure as I do not have a table top unit. I would assume it would take some DIY modifications as the table top unit has a smaller top.
Tim Myers said:
Greg, you may have answered my question in your post but let me make sure of that. I don't have room in my shop for the full size Kreg router table and will purchase the portable or table top model. Is it possible to add the better t-square style Kreg fence to the table top model down the road?
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
Hello - I have a couple of workbenches in my 'shop' and am contemplating putting 2 or 3 pull out bins on the bottom shelves of both. I've not worked with drawer slides before and am looking to make it simple(r). Thinking of making 2 sets of pocket…Continue
Tags: hole, pocket, basket, slide, Drawer
Started by E M Hampton in General Woodworking Jan 10.
My clamp to hold boards to my kreg jig no longer works. It won't move from it's spot and when I push the grey button on top, nothing happens. are there replacement parts for this?Continue
Started by Tammy in Beginners' Zone. Last reply by John Browne Jan 3.
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 2 Comments
1st impression when you hold this attachment in your hand: "not much to it", Kreg sure is makin' $$ here.
Then I installed it.. perfect fit, leaves just enough room to adjust the setting screw on my K4.
Then the real test, hook…
Posted by Grampy Meyer on February 23, 2020 at 11:36am — 2 Comments
© 2021 Created by KregRep.
Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service