Does Kreg Have a Micro Jig Mini like the mini for the big brother? I am attaching some arched spreaders to tapered legs of a table. The spreaders are on the diagonal and are 7/8s of an inch going into 1 1/8 inch tapered legs.Sure wish they mede a little single black jig with a 5/16 drill bit as the blue one is just a tad to big, but it might work.
Test piece seem to work ok. But its just a small piece og ley attached to a reject spreader I had. Got to figure out a way to clamp them too so they dont move when the screws bite. But that shouldnt be too hard.
Still, Id prefer to use a smaller drill bit in piece like this. So hey you guys at Kreg, when are you coming out with a micro mini?
Robert it went real smooth, but it is a good thing I save all my scraps till I am done because I needed the piece I cut the arched spreaders out of to give support so I could clamp the thing. It had the perfect matching curve and one flat side. So save everything till you're done.
I have been using the Automaxx 6" clamp for two plus years, and recently the clamp is impossible to close the handles to secure the work and my jig. I cannot close the handles no matter how much pressure I can exert. I open the clamp to max to reset…Continue
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…