Hi, All:
Some place I saw a picture of a case for carring and storing Kreg pocket hole jigs and the accessorys, that when opened up, made a work top for the jig it's self. I would like to build a case of that type, but can not find the picture or plans of it that I saw. Can anyone help?
Lowell
Tags:
If you look under the projects tab there is one made by R.E. Woods that might fit what you are looking for.
Hi, Al,
Thanks for the heads up on that case R.E.Woods build. That is real nice storage case. It is a very big case, maybe bigger than I need. I have been researching the project, and found a smaller one in the March issue of WOOD Mag. It gives me some ideas, but I'll probably design it myself.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service