Kreg Owners' Community

Hello,   

I'm building a simple stand ... 2x4's for the legs, and apron on all 4 sides that sits below and supports 24' x 20 " x 1" thick top.   HD holes and screws hold the angles of the apron and legs together... I'm happy with that.  The HD screws are beastly.

Now... I understand that I COULD cut the plywood top to fit inside the of the apron for the top and drill holes all around  into each apron side.  BUT... I need the 1" top to sit ON TOP  of the supporting frame as the 1" contributes to the required height of the project.   SO... the holes will be drilled into the 2x4's (underneath and inside) and the screws will go into but not protrude from the 1" top to fix it to the frame.

My question is... what depth to set the kreg jig / drill and what side coarse screw to use ?  I understand the process when making a butt joint out of two pieces of wood that are the same thickness, but am unclear what the "work piece" is in my situation ?

Views: 290

Reply to This

Replies to This Discussion

Never mind.  Found the chart !  Thanks guys ! 

https://www.dropbox.com/s/jvl0rf4kbwz4jrh/Kreg%20-%20Pocket%20Screw...

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

First time I really had a need for the ACS miter guide.

I've been using my Adaptive Cutting System table for a few years now, and it's been really solid. This past week was the first time I ever needed to use the miter guide though.I was rebuilding some shelving in a tiny closet and I discovered the…Continue

Tags: ACS

Started by Adam in General Woodworking May 6.

What thread and size screw to use 2 Replies

I am building a small trunk for a military friend to put some belongings in. I have made legs out of ash hardwood and will make the sides out of 1/2” or 3/4” Baltic birch plywood. The legs are 1.5” thick by 2” wide. So since I’m drilling pockets in…Continue

Started by Mike Bohannon in Beginners' Zone. Last reply by Jay Boutwell Apr 19.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…

Continue

Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments

© 2022   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_