Hi everyone : Has anyone purchased or tried the Incra I-box finger joint jig , looks pretty simple and accurate compared to my home made one that takes forever to get right.
Tags:
I have the Rockler sliding table jig about $60. It works well if your router table has a miter slot. Was able to make box joints on first try. Follow the directions and works great.
I like the Rockler model ''box joint jig''---
intended for use on a router table.
That's the one only box jig I have tried I was successful first try. Add a nice high fence and klamp the stock with kreg klamp good to go.
Gary,
How high was the fence you needed?
Gary roofner said:
That's the one only box jig I have tried I was successful first try. Add a nice high fence and klamp the stock with kreg klamp good to go.
I will take a picture of my setup. It comes with 3 sizes of box joints. I used the plastic trim white facia outside wood nice square and straight .
I promised to take a picture of my rockler box joint jig with my fence .
Gary,
How do you like the Bosch router table, pictured in your photo?
What are some of the advantages, you've find, that is to your liking?
Its compact and solid built however to high for my new workbench.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I've been using my Adaptive Cutting System table for a few years now, and it's been really solid. This past week was the first time I ever needed to use the miter guide though.I was rebuilding some shelving in a tiny closet and I discovered the…Continue
Tags: ACS
Started by Adam in General Woodworking May 6.
I am building a small trunk for a military friend to put some belongings in. I have made legs out of ash hardwood and will make the sides out of 1/2” or 3/4” Baltic birch plywood. The legs are 1.5” thick by 2” wide. So since I’m drilling pockets in…Continue
Started by Mike Bohannon in Beginners' Zone. Last reply by Jay Boutwell Apr 19.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2022 Created by KregRep.
Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service