Kreg Owners' Community

Just about everybody needs more bathroom storage, but it's one of the most challenging rooms in the house to fit another item into. This wall-mounted shelf makes a perfect addition because it's small, but it packs a lot into a little space. Two slatted shelves are the perfect place to store towels and other bath accessories. Plus, the shelf has a bar for hanging towels. 

The entire shelf is built from 1x2 boards that you can pick up in any home center. We were lucky enough to find cherry boards in our home center. Cherry definitely gives the shelf a classic look.
The plan is attached as a PDF below. If you would like to print the plan, save it to your computer, open it in Adobe Reader, and then select Print. You can download Adobe Reader for free here

Once you're done building, be sure to share your project to inspire others and show off your work! 

Views: 13466

Attachments:

Reply to This

Replies to This Discussion

This made a nice addition to my bathroom
Attachments:

I like your Design. I did this one for over a commode where I needed a lot of storage and a limited space.  

Here's a modification I made for my favorite daughter-in-law Anna.

It's made from red oak with a satin poly finish.  I also rounded over the corners to soften the look and feel.

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

First time I really had a need for the ACS miter guide.

I've been using my Adaptive Cutting System table for a few years now, and it's been really solid. This past week was the first time I ever needed to use the miter guide though.I was rebuilding some shelving in a tiny closet and I discovered the…Continue

Tags: ACS

Started by Adam in General Woodworking May 6.

What thread and size screw to use 2 Replies

I am building a small trunk for a military friend to put some belongings in. I have made legs out of ash hardwood and will make the sides out of 1/2” or 3/4” Baltic birch plywood. The legs are 1.5” thick by 2” wide. So since I’m drilling pockets in…Continue

Started by Mike Bohannon in Beginners' Zone. Last reply by Jay Boutwell Apr 19.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…

Continue

Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments

© 2022   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_