Kreg Owners' Community

i was making a picture frame, 3/4" stock 2" wide 45 degree angle
when i set up for the 3/4" the pocket hole either show thru the finished side or pokes thru into the glass rabbit
i ended up setting up for 1/2" and just used one pocket with 1" screw and glue
is there a better way to connect 45ed corners

Views: 199

Reply to This

Replies to This Discussion


With angled cuts like you are doing there is a very fine line on what will and won't work. With the material that you are working with being 3/4" thick using the proper settings will leave you with a hole that takes up 2 1/4". Which as you have found out will cause the hole to show on the finished side. Probably your best bet in this situation is to set your jig up for 1/2" material and use a 1 1/4" screw. This way you will still get the strength that you need without leaving noticeable holes in your frames. Try it on some scrap pieces first but this should take care of your problem.
thanks dan
that's all i could figure too
it did seem to work but only had room for one screw
its still stronger than just a flat glue joint

What you can do is put one screw from each side. This way you will still get the support of two screws. Sometimes with just one screw over time the joint can want to twist. With these two screws you will not have that problem.

Reply to Discussion


Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 


  • Add Videos
  • View All


Recent Workbench Survey Legitimacy

Yesterday, I received an email wanting my opinion on Kreg adding high end workbenches to their product line and wanted to know before I clicked the link if this is a legitimate survey or some phishing scam. Here's the link I was provided (…Continue

Started by JOHN W. GOETZ in Other Kreg® Products Dec 10, 2021.

Pantry slides for heavy application

  Recently purchased two 96" tall pantry cabinets that are 23" deep that only came with two adjustable shelves and two fixed, (one at about 55" and one at the very bottom).  Shelf holes in the walls are drilled 2" O.C.  Like most store-bought…Continue

Tags: drawer, slides, pantry, pull-out, 75-Lb

Started by Paul Coon in General Woodworking Aug 11, 2021.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…


Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…


Posted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments

© 2022   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service