Kreg Owners' Community

Hi,

Small shop shelf. I got all my pieces cut out, sanded, put in my homemade 90 degree jig. Attached all the shelves to the right side of the storage shelf but when I went to pocket hole the second side on there was no way I could get to the pocket holes with my drill. the shelf is only 9 inches and the Kreg drill bit alone is at least 5 inches. So I ended up counter-sinking and drilling from the outside of the 3/4 inch plywood and naturally the plywood went to H...!

I should have used nails I guess. What do you do when your Kreg Pocket Hole Jig project is to small to get a drill inside of to put in the screws to the second side???

Thanks in advance,

Bill in Las Vegas

Views: 1112

Reply to This

Replies to This Discussion

Another tool I find very useful, an offset power head driving attachment, for angle driving and in close quarters.

Offered by Milwaukee Tools.

It can be used in 360 degree positions.

The auxiliary arm, has an indexing design feature, that permits all angle pivoting adjustment---up, down, both sides, and at angles.

My initial investment in this tool, was for installing screws thru the sidewalls of electrical boxes, to affix them to wall studs.  

Works great for driving pocket hole screws in restricted spaces.

 > this end is equipped with a quick-change shaft, that snaps into driving tools.

Available at HD for $20.

Wax paper transfer.  Reverse image ink-jet printed onto wax paper.  Position and rub with a credit card or similar.

It works Ok on softer woods like hemlock & fir.  The image will bleed a bit on pine.  I haven't tried it on maple or other hard wood.

William Patterson said:

Hey Tim, How did you do the lettering on your jewelry box? Bill in Las Vegas

I have used a short #2 square driver and a 1/4" ratchet to drive in screws in a tight spot a time or two. Worked for me.

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Pantry slides for heavy application

  Recently purchased two 96" tall pantry cabinets that are 23" deep that only came with two adjustable shelves and two fixed, (one at about 55" and one at the very bottom).  Shelf holes in the walls are drilled 2" O.C.  Like most store-bought…Continue

Tags: drawer, slides, pantry, pull-out, 75-Lb

Started by Paul Coon in General Woodworking Aug 11.

Miter Saw Recommendation 1 Reply

I’m looking to upgrade my miter saw. I’m willing to invest a good amount of money to get one with the precision pocket hole joinery requires. Would anyone like to offer a recommended model?

Started by Joe Racz in Beginners' Zone. Last reply by Scott Davison Oct 6.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…

Continue

Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 8 Comments

© 2021   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_