Hi,
Small shop shelf. I got all my pieces cut out, sanded, put in my homemade 90 degree jig. Attached all the shelves to the right side of the storage shelf but when I went to pocket hole the second side on there was no way I could get to the pocket holes with my drill. the shelf is only 9 inches and the Kreg drill bit alone is at least 5 inches. So I ended up counter-sinking and drilling from the outside of the 3/4 inch plywood and naturally the plywood went to H...!
I should have used nails I guess. What do you do when your Kreg Pocket Hole Jig project is to small to get a drill inside of to put in the screws to the second side???
Thanks in advance,
Bill in Las Vegas
Tags:
Another tool I find very useful, an offset power head driving attachment, for angle driving and in close quarters.
Offered by Milwaukee Tools.
It can be used in 360 degree positions.
The auxiliary arm, has an indexing design feature, that permits all angle pivoting adjustment---up, down, both sides, and at angles.
My initial investment in this tool, was for installing screws thru the sidewalls of electrical boxes, to affix them to wall studs.
Works great for driving pocket hole screws in restricted spaces.
> this end is equipped with a quick-change shaft, that snaps into driving tools.
Available at HD for $20.
Wax paper transfer. Reverse image ink-jet printed onto wax paper. Position and rub with a credit card or similar.
It works Ok on softer woods like hemlock & fir. The image will bleed a bit on pine. I haven't tried it on maple or other hard wood.
William Patterson said:
Hey Tim, How did you do the lettering on your jewelry box? Bill in Las Vegas
I have used a short #2 square driver and a 1/4" ratchet to drive in screws in a tight spot a time or two. Worked for me.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service