Tags:
Wet the wood with a damp rag and you will see the 'invisible' smears. Sometimes this means it is too late as sanding might not get all the glue off.
The surefire way is to clean all the errant glue from around joints with a damp rag before it sets up.
Another way is to use the newer glues out that show up under ultraviolet light. Do that and you know exactly where the stain will not take without further work. However using the tape method mentioned above is probably the best way to prevent the need for the other systems.
what are the newer glues that glow in the dark..that sounds like a great way to make sure you got rid of all that glue without the smell or mess of either oilor mineral spirits , although i tried the minerial spirit trick and it let me know were there were 2 spots along a seam that i missed
Robert Sanford said:Another way is to use the newer glues out that show up under ultraviolet light. Do that and you know exactly where the stain will not take without further work. However using the tape method mentioned above is probably the best way to prevent the need for the other systems.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I have had the ACS for about a year. Was wondering if there any other blades, like a Diablo, that will fit the saw?Continue
Started by Randall H Gress in Beginners' Zone Feb 20.
I have been using the Automaxx 6" clamp for two plus years, and recently the clamp is impossible to close the handles to secure the work and my jig. I cannot close the handles no matter how much pressure I can exert. I open the clamp to max to reset…Continue
Tags: clamp, inch, 6, Automaxx
Started by Anthony M Calabrese in Other Kreg® Products Feb 12.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 4 Comments
© 2021 Created by KregRep.
Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service