Kreg Owners' Community

Just took delivery of a variety of Kreg products and will be experimenting this coming week with the skills necessary to build some simple projects.   I assume using the drill's chuck gauge (clutch, right?) properly will help keep over tightening and head striping to a minimum.  Does anyone have a range of settings that would best apply to pocket joinery for various type sof wood?  Working with poplar to start, but expect to move up in hardness as skills improve.  Thanks in advance...

Views: 3759

Reply to This

Replies to This Discussion

John,
For drilling, you'll want to set the clutch to "Drill." For screws, you certainly don't want to be on the "Drill" setting. If you're new at this, experiment on some scrap wood first to find your best setting. We recommend starting lighter, somewhere around 4-6. Our friend Chris at Chief's Shop recommends starting somewhere in the middle. For softwoods, go a bit lower, and for hardwoods, a bit higher. He offers more tips on drill/driver settings here: http://www.youtube.com/watch?v=Oj-zXtt6ZJU.
KregRep

Good advice, and a good video. I've found that I start low and work up; use just enough force to get the screw to seat well, and no more. With softwoods and sheet stock especially (plywood or mdf), you run the risk of tearing the screw out if you overtighten. Drilling in a scrap piece is always a good idea; that also helps you to check your depth settings before you start drilling into your project pieces!

Couple of suggestions, learned from experience;

  • When moving from one type of wood to another, remind yourself to reset the clutch.
  • When you finish drilling and start assembly, remind yourself to reset the clutch

I try to make it a habit to check and reset the drill every time. Saves on wood, time AND frustration!

I generally use a light-torque setting, and make the final tightening, 

using a hand driver.

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

First time I really had a need for the ACS miter guide.

I've been using my Adaptive Cutting System table for a few years now, and it's been really solid. This past week was the first time I ever needed to use the miter guide though.I was rebuilding some shelving in a tiny closet and I discovered the…Continue

Tags: ACS

Started by Adam in General Woodworking May 6.

What thread and size screw to use 2 Replies

I am building a small trunk for a military friend to put some belongings in. I have made legs out of ash hardwood and will make the sides out of 1/2” or 3/4” Baltic birch plywood. The legs are 1.5” thick by 2” wide. So since I’m drilling pockets in…Continue

Started by Mike Bohannon in Beginners' Zone. Last reply by Jay Boutwell Apr 19.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…

Continue

Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments

© 2022   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_