Kreg Owners' Community

OK, I just noticed there is a difference of 1/8 of an inch in the drill collar setting on the K3 and K4 jig base. Which is correct? The K4 has the clamp handle in the back, the K3 has the clamp handle in the front just for clarification. Somewhere I saw a chart with the actual measurements if you didn't have the jig base handy. Couldn't find that or it would probably have answered my question.

Views: 4053

Reply to This

Replies to This Discussion

In the user's manual is a chart showing how to set the collar on the drill bit for the size wood you using, below is a copy of it.....

I hope this is what you were looking for. :)

Thanks James. That's exactly what I was looking for.

The funny thing is though, like the different bases different instructions are different as well. I have another set of instructions that say for 1-1/2 to set the collar at 4-1/4 inch. So regardless of where you get your settings from they are not consistent. Looking at where this bit sits in the base with either of these settings you sure wouldn't want to use the "nickle" trick some have suggested as that would put your screw clear out the backside of your work-piece. The one thing I have learned from all of this is to take the prescribed settings as a suggested starting place and TEST with a piece of scrap before committing yourself. If your jig was 1/8 inch too long and your work-piece was 1/8 inch too thin your screw just got 1/4 inch too long and that could spell disaster.

Anyway, thanks for the response and I'll go find a piece of scrap to test on. :-)

James Waller said:

In the user's manual is a chart showing how to set the collar on the drill bit for the size wood you using, below is a copy of it.....

I hope this is what you were looking for. :)

We, in the UK use Metric Dimensions. any chance of making a jig with metric markings? I don't even have inches on my Tape!!

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

First time I really had a need for the ACS miter guide.

I've been using my Adaptive Cutting System table for a few years now, and it's been really solid. This past week was the first time I ever needed to use the miter guide though.I was rebuilding some shelving in a tiny closet and I discovered the…Continue

Tags: ACS

Started by Adam in General Woodworking May 6.

What thread and size screw to use 2 Replies

I am building a small trunk for a military friend to put some belongings in. I have made legs out of ash hardwood and will make the sides out of 1/2” or 3/4” Baltic birch plywood. The legs are 1.5” thick by 2” wide. So since I’m drilling pockets in…Continue

Started by Mike Bohannon in Beginners' Zone. Last reply by Jay Boutwell Apr 19.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…

Continue

Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments

© 2022   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_